Table of Contents
Advertisement
10
VSR
User Manual
Alarm Record Reset
This feature is for future development, and has not yet been implemented.
Error Out
The Error Out signal is activated when the unit experiences any operational or internal error.
Video Loss Out
The Videoloss Out signal is activated when the unit experiences videoloss on the video input (Composite). In
the event of videoloss, VIDEOLOSS will be indicated near the upper left hand corner of the primary monitor.
Videoloss is defined as the inability to successfully lock on either horizontal or vertical sync frequencies at the
video inputs.
Disk End Out
The Disk End Out is activated when there is less than 1% of recording space left on the hard disk. The VSR
must be in Record mode and not set to Continuous Overwrite.
Power Connector
Plug the power cord into the power cord connector and then into a properly rated wall socket. Once power is
applied to the unit, it will begin its power-up procedure. The unit will begin by displaying the software version
on Monitor-A, then the unit will begin recording automatically.
Table 6.
Power supply rating
Voltage Input
Amps
Voltage Output
Connector
Ethernet Port
The cable connection configuration for the ethernet port depends on your network configuration:
•
For a VSR that connects directly to a hub, use a straight through connection.
•
For a VSR that connects directly to a PC, use a cross-over connection.
Power supply
100-240 VAC 50-60 Hz, auto-ranging
1.65-0.85 A
12 VDC
2.1 mm barrel, center positive
Advertisement
Table of Contents
