Accessing The Modem's Homepage - CalAmp 882?EVDO?XXX User Manual

Find and select "Internet Protocol (TCP/IP)" from the list box and then click the "Properties" button
(Figure 3.1). The TCP/IP configuration window will pop up, refer to Figure 3.2. Under the General
tab, select radio button "Obtain an IP address automatically" and "Obtain DNS server address
automatically" (Figure 3.2). Click the OK button to close TCP/IP configuration window. Click the
Close button to complete the computer preparation for the 882-EVDO modem.
Figure 3.2: Internet Protocol (TCP/IP) Properties Screen
Defaults will be:
IP address: 192.168.1.120-200 (typically 120)
Subnet mask: 255.255.255.0
Gateway: 192.168.1.50 (DNS will also be this)
Connect an antenna to the RF connector on the front panel of the 882-EVDO modem. Connect the
Ethernet cable into the 882-EVDO modem's Ethernet Port and plug the other end into the network
port of your PC. Connect the Power Adapter to the 882-EVDO modem and plug into a proper AC
power socket. The Power LED on the panel should activate. The Service LED (SVC TYPE) and RSSI
LED will light green to indicate the 882-EVDO has finished starting up and is functioning.

Accessing the Modem's Homepage

Approximately one minute after applying power to the unit, start your web browser and enter
192.168.1.50 in the address bar. A login screen should appear, enter the User Name: admin and
the Password: password and click OK. Refer to Figure 3.3.
Figure 3.3: 882-EVDO Browser Connection Login Screen
Page 16 of 62