Operation; Before You Begin; Location Of Controls - Travis Industries DVS FIREPLACE Owner's Manual

O
PERATION
P 28
AGE

Before You Begin

! Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 2 & 3). Failure to follow the instructions may result in property
damage, bodily injury, or even death.
Location of Controls - See explanation below
Gas Control
Valve
Gas Control
Knob
Blower Knob
On/Off Switch
Pilot Igniter
Gas Control Knob
Flame Adjust Knob
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off
Switch "OFF" will keep the fireplace off always.
Swing the control cover down
to access the gas control valve,
igniter, and blower control.
PILOT ADJ
Flame Adjust
Knob
This knob controls the speed of the internal convection blower that pushes the
heated air into the room.
This control is used to turn the fireplace on and off.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer directly below the
knob indicates the position this knob is in.
This knob controls the flame height from low ("LO") to high ("HI"). The
pointer to the upper left of the knob points to the position this knob is in.
The Pilot Flame can be found below
the back log on the left side.
ON/OFF Switch
PILOT
ON
IGNITER
OFF
Pilot Igniter
OFF
HI
LO
Blower Knob