Facing Requirements; Facing Over 1" Thick - Travis Industries DVS FIREPLACE Owner's Manual

I
NSTALLATION
P 10
AGE

Facing Requirements

¥ The combustible area above the facing must not protrude more than 3/4" from the facing. If it
does, it is considered a mantel and must meet the mantel requirements listed in this manual.
21-9/16" Discovery & Rosario
22" FPX Arch & Rect.
21-1/2" Heritage Bay & Cambridge
22-1/2" Salish Bay
Bottom of
Faceplate
acing Over 1" Thick
¥ If the facing material
is over 1" thick (e.g.
brick, river rock),
install the facing
around the perimeter
of the face. You may
wish to make a
facing support (see
the illustration to the
right). If using an
arch face, you may
wish to order the
optional set-up face:
Arch Set-Up Face
Part # 98500697
(C .)
ONT
- For Qualified Installers Only!
12" Min.
Arch Face
Note: if using a brick hearth, the fireplace will need to be raised to accommodate the 1-1/2Ó gap betwen the
face and the base of the fireplace. For 2-1/2Ó thick brick this works out to approximately 1-1/8Ó.
Rectangular Face
32" Discovery & Rosario
30" FPX Arch & Rect.
31-5/8" Heritage Bay
30-1/2" Salish Bay
33-7/8" Cambridge
The brick facing must meet the same requirements
listed in ÒFacing RequirementsÓ above.
Center
Line
Arch Faces
Use the optional Arch
Set-Up Face available
from Travis
Industries.
1-1/2Ó
The fireplace requires a concrete
board (or other non-combustible)
extending from the header to the
floor and to the framing members on
both sides. Do not use sheetrock,
plywood or other combustible
material.
Header
Non-combustible Facing
6" Min.
(both sides)
Face Sizing:
HEIGHT:
21-9/16" Lopi Discovery Face
21-9/16" Avalon Avanti Face
22" FPX 32 Arch Face
22" FPX 32 Rect. Face
WIDTH:
32" Lopi Discovery Face
32" Avalon Avanti Face
30" FPX 32 Arch Face
30" FPX 32 Rect. Face
Rectangular Faces
Make a facing support using
2x4Õs. It should be 1/8Ó larger
than the finished face. NOTE:
The bottom of the face is 1-1/2Ó
above the base of the fireplace.