Troubleshooting - Petsafe Wireless Pet Containment System Receiver Collar Operating Manual

The Receiver Collar
is not beeping
when setting up the
Boundary Zone.
The Receiver Collar
is not beeping or
administering a
Static Correction.
The Receiver
Collar is beeping
everywhere.
10

Troubleshooting

• The beep may be diffi cult to hear in a noisy environment.
• Use Test Light as explained in the "Test Light Instructions"
section, and use it to determine the location of Boundary Zone.
• Check that the Transmitter is set up according to directions
and install a new battery within 5 feet of the Transmitter.
• Re-Synchronize the System. (page 14)
• Check that the Transmitter is plugged into a working
120-volt outlet, turned on, the Power Light is on, and the
Transmitter controls are set at your desired settings.
• Check Receiver battery to make sure it is installed properly.
• When replacing the battery, do so within 5 feet of the Transmitter.
• Re-Synchronize the System. (page 14)
• Check that the Transmitter is plugged into a working
standard 120-volt outlet, turned on, the Power Light is on,
and the Transmitter controls are set at your desired settings.
• Bring Receiver Collar within 5 feet of the Transmitter to reset.
• Re-Synchronize the System. (page 14)
1-800-732-2677