7.
Trim the collar as follows (
a.
Mark the desired length of the Receiver Collar with a pen. Allow for growth if
your pet is young or grows a thick winter coat.
b.
Remove the Receiver Collar from your pet and cut off the excess.
c.
Before placing the Receiver Collar back onto your pet, seal the edge of the cut
collar by applying a fl ame along the frayed edge.
8.
Put battery in Receiver Collar.
Important: For comfort, safety and effectiveness of product, please ensure
the following:
•
During the first 2 weeks of training, do not use the training device on your pet
without direct supervision.
•
Check the fit to prevent excessive pressure by being able to insert one finger
between the Contact Point and your pet's skin.
•
Never leave the receiver Collar on your pet for more than 12 consecutive hours.
•
Your pet must be carefully examined daily for any signs of a rash or sore.
•
If a rash or sore is observed, discontinue the use of the Receiver Collar for a
few days.
•
If the condition persists beyond 48 hours, see your veterinarian.
•
Your pet's neck and the Contact Points must be washed weekly with a wash
cloth and mild hand soap, then rinsed thoroughly.
A condition called Pressure Necrosis, which is a devitalization of the skin due
to excessive and prolonged contact against the Contact Points, may occur if the
steps above are not followed.
H):
www.petsafe.net
7
Need help?
Do you have a question about the Wireless Pet Containment System Receiver Collar and is the answer not in the manual?
Questions and answers
Will the "PetSafe Little Dog " receiver (PIG19-11042) work with the older PetSafe **** Containment System transmitter RF-1002?