Tx Gnrl Group; Tgen Emrgncy - Yaesu FTdx5000 Series Operating Manual

Hf/50 mhz transceiver
Hide thumbs Also See for FTdx5000 Series:
Table of Contents

Advertisement

M
M
169 TGEN BIAS
Function: Adjusts the Bias level of the Final Amplifier
while in "Class-A" operation.
Available Values: 1 ~ 100
Default Setting: 100
170 TGEN MAX PWR
Function: Selects a maximum output power limit.
Available Values: 20W / 50W / 100W / 200W
Default Setting: 200W
171 TGEN PWR CTRL
Function: Configures the [ RF PWR ] knob.
Available Values: ALL MODE / CARRIER
Default Setting: ALL MODE
ALL MODE: The [ RF PWR ] knob is enabled on all
modes.
The [ RF PWR ] knob is enabled in all
CARRIER:
modes except SSB. In this configuration,
the SSB output power will be set to
maximum, regardless of the [ RF PWR ]
knob's position.
172 TGEN ETX-GND
Function: Enables/Disables the TX GND jack on the rear
panel.
Available Values: DISABLE / ENABLE
Default Setting: DISABLE
173 TGEN TUN PWR
Function: Selects a maximum output power limit for driv-
ing the input circuit of an external linear RF amplifier while
tuning (while using the Remote Control function of the
linear RF amplifier).
Available Values: 20W / 50W / 100W / 200W
Default Setting: 100W
Page 136
TX GNRL G
174 TGEN VOX SEL
Function: Selects the audio input source for triggering TX
during VOX operation.
Available Values: MIC / DATA
Default Setting: MIC
MIC: The VOX function will be activated by micro-
DATA: The VOX function will be activated by data
175 TGEN ANTI VOX
Function: Adjusts the Anti-VOX Trip Gain, which is the
level of negative AF feedback of receiver audio to the
microphone, to prevent receiver audio from activating the
transmitter (via the microphone) during VOX operation.
Available Values: 1 ~ 100
Default Setting: 100

176 TGEN EMRGNCY

Function: Enables Tx/Rx operation on the Alaska Emer-
gency Channel, 5167.5 kHz.
Available Values: DISABLE / ENABLE
Default Setting: DISABLE
When this Menu Item is set to "ENABLE", the spot fre-
quency of 5167.5 kHz will be enabled. The Alaska Emer-
gency Channel will be found between the Memory chan-
nels "P-1" and "01 (or 1-01)".
I
The use of this frequency is restricted to stations operat-
ing in or near Alaska, and only for emergency purposes
(never for routine operations). See §97.401(c) of the FCC's
regulations for details.
phone audio input.
audio input.
:
FT
5000 O
DX
M

Advertisement

Table of Contents
loading

Table of Contents