Display Indications - Yaesu FTdx5000 Series Operating Manual

D I
ISPLAY NDICATIONS L
VFO-A Block Diagram Display
ANT 1, 2, 3, 4, RX :
Indicates the antenna selected for operation by the front
panel [ ANT 1-4 ] and [ RX ANT ] switches.
ATT OFF, –6 dB, –12 dB, –18 dB :
Indicates the attenuation level selected for operation
by the front panel [ ATT ] button.
FLT VRF, µ-TUNE, THRU :
Indicates the RF filter selected for operation by the
front panel ( VFO-A )[ VRF/µ-T ] button.
A :
The µ-TUNE filter is an option. The "
not appear when the optional µ-TUNE unit is not con-
nected.
IPO AMP1, AMP2, IPO1, IPO2 :
Indicates the front end RF amplifier selected for op-
eration by the front panel [ IPO ] button.
R.FLT 300, 600, 3k, 6k, 15k :
Indicates the 1st IF Roofing Filter selected for opera-
tion with the front panel [ R.FLT ] button.
A :
The 300 Hz Roofing Filter is an option except the MP
version. The "300" icon will not appear when the op-
tional 300 Hz Roofing Filter is not installed.
AGC AUTO, FAST, MID, SLOW :
Indicates the AGC decay time selected for operation
by the front panel [ AGC ] switch.
Page 30
S
VFO-A Status Indicator
This indicator appears during transmission on the VFO-
A frequency.
This indicator appears whenever the VFO-A receiver
squelch is open. If this indicator is not showing, and
reception seems to have been lost on the VFO-A re-
ceiver for no apparent reason, check the position of
the ( VFO-A )[ SQL ] knob, and rotate it fully counter-
clockwise to restore reception.
" icon will
This indicator appears when the Main Tuning Dial tun-
ing rate is selected to fast.
This indicator appears when the Main Tuning Dial knob
is locked.
,
Displays the currently-selected operating mode for
VFO-A.
This indicator appears whenever the VFO-A receiver's
narrow IF DSP filter is engaged.
The "
(short duration) Noise Blanker is activated.
The "
(longer-pulse) Noise Blanker is activated.
:
:
:
:
, , , ,
" icon appears when the VFO-A receiver's
" icon appears when the VFO-A receiver's
FT 5000 O
DX
,
M