Transmitting In The Beacon Mode - Yaesu FTdx5000 Series Operating Manual

C CW M
1. Be sure that Break-in is still turned "off" by the [ BK-
IN ] button.
2. Press the [ MONI ] button to enable the CW monitor.
3. Press the FH-2's [ 1 ] ~ [ 5 ] key to check
your work. You will hear the results in
the sidetone, but no RF energy will be
transmitted.
N :
Adjust the monitor level using the [ MONI ] knob.
It is possible to automatically transmit a "Beacon" message repetitively. The message may be input either with the
keyer paddle, or programmed using the MENU "TEXT" input method. The time delay between message repeats
may be set anywhere between 1 ~ 255 seconds via Menu item "022 KEY BEACON". If you do not wish the
"Beacon" message to repeat, then, set this Menu item to "OFF". Press a [ 1 ] ~ [ 5 ] key on the FH-2 Remote Control
Keypad, to select the register into which the Beacon message was stored. Repetitive transmissions of the Beacon
message will begin. Press one of these keys once more to halt the Beacon transmissions.
FT 5000 O
DX
CW C
C M
ONTEST
C
LOCK
ON OFF

Transmitting in the Beacon Mode

M
ONVENIENCE
K
EMORY EYER
O -T -A CW M
1. Press the [ BK-IN ] button to enable transmission. Ei-
ther Full- or Semi-break-in will be engaged, depend-
ing on the setting of Menu item "063 A1A BK-IN".
2. Press an FH-2's [ 1 ] ~ [ 5 ] key to trans-
mit the programmed message.
N :
If you subsequently decide to use the "Text Memory" tech-
nique for message storage, on a particular memory regis-
ter, the contents of a message stored using the keyer paddle
input will not be transferred over when the Menu Mode
Setting is changed to "TEXT").
F
EATURES
P
LOCK
ON OFF
Page 95