Rx Audio Group; Rx Gnrl Group - Yaesu FTdx5000 Series Operating Manual

M M
MODE-SSB G
105 A3J LSB CAR
Function: Adjusts the receiver carrier point for the LSB
mode.
Available Values: –200 Hz ~ 200 Hz (10 Hz/steps)
Default Setting: 0 Hz
106 A3J USB CAR
Function: Adjusts the receiver carrier point for the USB
mode.
Available Values: –200 Hz ~ 200 Hz (10 Hz/step)
Default Setting: 0 Hz
RX AUDIO G
107 ROUT AGC SLP
Function: Selects the gain curve of the AGC amplifier.
Available Values: NORMAL / SLOPE
Default Setting: nor
NORMAL: The AGC output level will follow a lin-
ear response to the antenna input level,
while AGC is activated.
SLOPE: The AGC output level will increase at 1/
10 the rate of the antenna input level,
while AGC is activated.
108 ROUT HEADPHN
Function: Selects one of three audio mixing modes when
using headphones during Dual Receive operation.
Available Values: SEPARATE / COMBINE1 /
COMBINE2
Default Setting: SEPARATE
SEPARATE: Audio from the VFO-A receiver
is heard only in the left ear, and
VFO-B receiver audio solely in
the right ear.
COMBINE1: Audio from both VFO-A and
VFO-B receivers can be heard
in both ears, but VFO-B audio
is attenuated in the left ear and
VFO-A audio is attenuated in
the right ear.
COMBINE2: Audio from both VFO-A and
VFO-B receivers is combined
and heard equally in both ears.
Page 130
SLOPE
NORMAL
Input Signal
RX GNRL G
109 RGEN IF OUT
Function: Enables/Disables the 9 MHz RX IF signal from
the rear panel IF OUT jack.
Available Values: DISABLE / ENABLE
Default Setting: DISABLE
110 RGEN MNB LVL
Function: Adjusts the noise blanking level of the VFO-A
IF noise Blanker.
Available Values: 0 ~ 100
Default Setting: 50
111 RGEN MNB WDTH
Function: Adjusts the bandwidth for the longer-duration
pulse noise of the VFO-A IF noise Blanker.
Available Values: 0 ~ 100
Default Setting: 50
FT 5000 O
DX
M