MICOM-2E-ALE Owner's Manual
Step 1. Insert a small, flat-blade screwdriver in the slotted area on the
right hand-side panel of the radio and press the screwdriver
towards you, to release the Control Head.
Figure 12: Opening the Control Head
Step 2. Disconnect the internal speaker from the board.
Step 3. Return the top cover to its original position by applying pressure
on both sides of the cover. Observe that the seal is correctly
located.
Operational Checks
When installation is complete, carefully check all operating functions
(refer to the Operation section). In case of malfunctioning, refer to
Troubleshooting and Tuning the Antenna paragraphs in this manual.
78