Power Save; Setting Time - Wildgame W4E User Manual

Power Save

1.
After 30 seconds without any buttons
being pushed, the LCD will turn off and
camera enters into Power Save or
Ready Mode.
2.
The LCD screen can be awakened by
pressing the Power button briefly.
Note: The LCD will not "wake up" when
camera is writing to memory.

Setting Time

1.
To change date and time, start by
pressing and release the center
navigation button to set the hour.
Time/Date
Location
PIR Mode
Trigger
Flextime P1
PIR Mode Still
PIR Active
24Hr
PIR Sense
Hi
Picture
Regular
Resolution
Hi
Delay
15s 30s
2.
Press the left or right navigation
button to go up or down in sequence.
Time/Date
Location
Trigger PIR Mode
Flextime P1
PIR Mode
Still
PIR Active
24Hr
PIR Sense
Hi
Picture
Regular
Resolution
Hi
Delay
15s 30s
3.
When the hour is set, repeat steps 1
and 2 to set the minutes.
Flextime Both
P2 Interval
Video
Day Night
Med Lo
Wide
Med Lo
1m 2m 5m 10m
Open
Flextime Both
P2 Interval
Video
Day Night
Med Lo
Wide
Med Lo
1m 2m 5m 10m
Open
page 6
PO
POWER