Buffalo Tech WPL-05G300 Series User Manual page 17

Chapter 2 Installation
3
Check that the LEDs appear as shown below.
Power
PLC
Wireless
Router
For LED locations, refer to chapter 1.
4
Room 2
PLC button
5
Room 2
AirStation
6
Check that the PLC LED changes to steady green after about 1 minutes.
Note: If the PLC LED does not turn steady green after about one minute, perform the setup procedure again
from the beginning.
WPL-05G300 Series User Manual
Green LED on
Off
Green LED on or blinking
Off
Hold down the PLC button of the AirStation installed in
step 2 until the power LED starts blinking green (about
2 seconds).
AirStation
Room 3
PLC button
Within 2 minutes, hold down the
PLC button of the AirStation that
was installed in step 1 until the
power LED starts blinking green
(about 2 seconds).
AirStation
(Extender kit)
16