Table of Contents
Advertisement
2.2 DVR System Registration
You can register a DVR to control via RS-485 or network connection. In the Basic mode, the DVR's system ID set in each DVR is required to control DVRs.
In the Advanced mode, the user-defined ID registered on the network keyboard is required to control DVRs.
Basic Mode
You can control a DVR with the DVR's system ID after setting up the port information for the RS-485 communication without registering the DVR.
Refer to Chapter 5 – Remote Configuration, 5.3 Device for details on the remote setup. The following is about the registration by using the LCD menus.
.
Connect a DVR to the RS-485 DVR port of the network keyboard referring to the DVR's User's Manual.
.
Enter the LCD menu by pressing the
Refer to Chapter 4 – LCD Menu Configuration for details on entering and configuring the LCD menu.
3.
Go to the Device –> General menu.
•
Setup Type: Select Basic (Basic mode)
•
Port: Select DVR and set up the port information for RS-485 communication referring to the settings in the DVR.
4.
Check the DVR's system ID set in the DVR. You have to change the DVR's system ID in the DVR if the system ID is in use in more than one DVR or set to
„0." The system ID will be used to distinguish the DVR from other DVRs when controlling it by using a network keyboard, so each DVR should have its
own unique system ID.
Advanced Mode
DVRs can be registered on the network keyboard remotely by using the INIT program. Refer to Chapter 5 – Remote Configuration, 5.3 Device for details on
the remote registration.
.
Connect a DVR to the RS485 DVR port of the network keyboard via RS-485 connection or to a network referring to the DVR's User's Manual.
.
Run the INIT program and connect to the network keyboard to register the DVR. Refer to the INIT User's Manual for details on the INIT program.
Go to the following menus: Setup –> Remote Setup – > Network –> IP Address
3.
Set up the network keyboard's network connection information.
4.
Go to the following menus: Setup –> Remote Setup –> Device –> General
Select Advanced from the Setup Type drop-down list. If the DVR is connected to the
network keyboard via RS-485 connection, set up the port information for RS-485
communication.
and
button together of the network keyboard.
Advertisement
Table of Contents
