Ip Address Validation Messages - Kodak 3H0610 Manual

Bad status from target
device: <n>. Press
CANCEL to exit
program
Unable to open SNMP
Session
Bitmap Init Error
Unable to load
NPAPI.DLL
Unable to load
NPSNMP.DLL
WINSNMP Error (%ld)
sending%s packet

3.11.2 IP Address Validation Messages

The following table displays messages that you may see when entering
an IP address:
More than 3 dots exist in the address or No
characters present between dots or Invalid
character in IP Address or The address
contains one Þeld with value more than 255.
Not all Þelds are deÞned.
General Messages
Message
Appears when the
SNMP agent on device
returns a
NO_SUCH_NAME for a
particular OID
Usually appears if the IP
stack on the manager
has died
Application is not able to
Þnd the bitmap
File NPAPI.DLL could
not be found
File NPSNMP.DLL could
not be found
Appears when the
manager is not able to
send a WINSNMP
packet. Sometimes
occurs due to an SNMP
agent in the device that
crashed.
IP Address Validation Messages
Message
Cause
The Þrmware on the agent
does not match with the
version of the Manager
software. Upgrade the agent
Þrmware and the
FastManage Software
Package.
Restart Windows.
The FastManage installation
may be bad. Reinstall.
Put the Þle NPAPI.DLL in the
path.
¥ Put the Þle NPSNMP.DLL in
the path.
¥ Set NetBeui as a default
using the Network Control
Panel.
Use the PING application to
Þnd out if the agent device is
reachable. If yes, restart
Windows. If not, power cycle
the device and try again.
A valid IP address is of the form
a.b.c.d, where a.b.c.d can vary
from 0 to 255. For example,
193.25.86.214
Solution
Solution