Zñreset Nvram To Factory Defaults; Ñprint Postscript Test Page; Finishing Up A Telnet Session - Kodak 3H0610 Manual

NIC Telnet
A
P
P
E
N
D
I
X
A
A.4.8 ZÑReset nvram to factory defaults
A.4.9 +ÑPrint PostScript test page
A.5 Finishing Up a Telnet Session
A-6
Modify?, yes or no (y or n)?:n
TCP/IP menu options: (S) Socket Options
TCP Sockets enabled
Modify?, yes or no (y or n)?:n
TCP/IP menu options: (L) LPD Options
LPD enabled
LPD mode: DonÕt time out on printer error
Modify?, yes or no (y or n)?:n
TCP/IP menu options: (X) Exit
Also reset IP address?, yes or no (y or n)?:n
nvram reset to factory defaults
Printing PostScript test page on printer
If, when you Þnish a telnet session, you made no changes, you may
simply end your Telnet session.
If you changed one or more parameters:
1. Type R to Reset the NIC using the new parameters
2. Power cycle the printer to synchronize the printer and NIC.
To prevent unauthorized Telnet sessions that could cause conÞguration
changes, set the faceplate mode switches to Normal mode (D1 & D2 in
UP position), then power cycle the printer.
July 1998