LEGRAND Omizzy User Manual page 22

Configuration (continued)
- Procedure No. 2 :
This procedure requires the use of a PC.
Press and hold down the "Sel pushbutton ( )".
Press the pushbutton ( ) on the remote control.
Check that the yellow "TEST ( )" indicator lamp
lights.
Transmit a second pulse.
Check that the yellow "PROG ( )" indicator lamp
lights.
Release the "Sel" pushbutton.
Press pushbutton "P"
on the control panel.
The yellow indicator lamp
lights and there is an
audible beep.
Caution :
This operation deletes all the remote controls which have pre-
viously been registered.
Remember to re-register them before quitting "PROG" mode
Attach the 2 lenses and
press the pushbutton.
A beep sounds. A short
audible signal indicates
that the remote control
teach phase has been
successful.
22
~
A U X
P
S e l
I / O
P
S e l
P
S e l
A long audible signal (approximately 4 seconds)
indicates that the programming has been unsuccess-
ful (repeat the operation).
Repeat this operation for each of the remote con-
trols to be stored.
Then click on the eye of the intruder alarm control
panel ("Control", "Alarm").
~
A U X
P
S el
I / O
The
activated/desactivated from the server.
.
~
A U X
I / O
When the programming
~
has been completed,
press
A U X
P
S e l
P
S e l
pushbutton.
I / O
The yellow indicator lamp
( ) goes off.
control panel can
the "Sel ( )"
now be