Quantity - VKI Technologies Eccellenza Pod Operation Manual

Operation Manual

Quantity

This setting allows you to set the quantities for the coffee water, powder product and powder water.
To set the quantities,
1. Enter the Set-Up mode and scroll to the Quantity menu.
2. Press the Enter () button.
3. Scroll UP to the set the setting required. In this case, the Coffee Pump quantity will be calibrated
(the same procedure applies for adjusting the quantity of powders and powder water).
4. Place a measuring cup in the dispensing area.
5. Press the Enter () button to begin calibration. The screen will display;
6. The machine will now dispense a preset amount of water for several seconds. Measure the
quantity of water that is dispensed. In this case, we'll use 68ml as an example.
7. Once done dispensing, the screen will show the following;
8. Press the Enter () button to set the quantity measured.
9. Use the Regular or Bold Strength buttons to increase or decrease the setting. In this case, use
the Regular button to increase the setting to 68.
10. Once set, press the Enter () button to save the changes.
NOTE: You can also measure the quantity of water by weighing it on a scale.
For example, if you measure 68 grams of water on the scale, that equates to
approximately 68 ml (1ml=1gr).
Eccellenza Pod
29