VKI Technologies Eccellenza Pod Operation Manual page 16

Eccellenza Pod
6. Remove the hopper lids.
7. Refill the two hoppers with product – milk in the left hopper and chocolate in the right hopper.
NOTE: Do not pack the powder inside the hoppers.
8. Re-install the powder hoppers, and rotate the spout caps to unblock each of the hopper spouts.
NOTE: To reduce the risk of powder 'bearding' or clogging the dispenser spouts, make
sure the spouts are pointing straight down (as illustrated above). A retainer on the
upper vacuum duct plate will stop the spouts when they are in their proper position.
9. If the hoppers have been removed for more than 10 seconds, the machine will automatically reset
the Powder (1 and/or 2) counter(s).
10. The machine will then show the Powder System Rinse menu on the LCD. This rinse is
mandatory must be performed to reduce the possibility of the residual powder clogging whipper
system.
11. Place a large cup under the dispensing spouts.
12. Press the Start button to begin the powder rinse cycle.
13. Once the cycle is finished, the machine automatically reverts to the Standby (ready) mode.
14. Re-install the waste bin.
15. If the waste bin has been removed for more than 10 seconds (default setting), the machine will
automatically reset the Waste Bin counter. The "Reset Time Out" setting can be changed from 10
seconds to another value in the Counters menu.
16. The machine will then show the Powder System Rinse menu on the LCD. This rinse is mandatory
must be performed to reduce the possibility of the residual powder clogging whipper system.
17. Once done, the machine automatically reverts to the Standby (ready) mode.
18. Re-install the drip tray.
16
Operation Manual