NEC EXP200 User Manual page 96

4-34 Configuring Your Server
RAID Configuration by Array Configuration Utility (ACU)
This section describes how to configure the RAID by using the "Array ConfigurationUtility (ACU)"
that can be called from POST.
NOTE:
NEC EXPRESSBUILDER. See Chapter 6 for details.
Running the Array Configuration Utility (ACU)
To start ACU:
NOTES:
Make sure that the BIOS has been changed according to "Enabling
RAID Feature by BIOS SETUP Utility".
To start the ACU from management PC via serial (direct)
connection or via network, see also "NEC EXPRESSBUILDER" in
Chapter 6.
1.
Start the server.
2.
To run ACU, press Ctrl + A when prompted by the following message during the system
startup:
Press <Ctrl><A> for Adaptec RAID Configuration Utility
NOTE:
unit, press Ctrl + A three to five seconds after power-on.
After a while, the ACU menu appears.
You can configure the RAID drive by using Express Setup of
If it takes a long time until a message appears on the display
To change or delete RAID
configuration
To perform low-level
formatting or verification of
RAID drive