Power Supply; Peripheral Bays; Remote Power-On Feature (Wake On Lan) - NEC EXP200 User Manual

2-10 General Description

Power Supply

The system contains one auto-sensing 380-watt power supply at an operating frequency of 50/60
Hz.
The power supply is designed to comply with existing emission standards and provide sufficient
power for a fully loaded system configuration.

Peripheral Bays

The system supports a variety of standard PC AT-compatible peripheral devices. The chassis
includes these peripheral bays:
One 3.5-inch file bay for installing the standard 3.5-inch floppy disk drive (supports
720KB and 1.44MB floppy disk media) or an optional file device.
Two 5.25-inch file bays for installing half-height 5.25-inch peripheral devices such as an
optional tape drives. (An ATAPI CD-ROM drive is factory-installed.)
The hard disk drive bays for installing up to four ATA150 or SCSI hard disk drives.
NOTE:
file devices (or one hot-swap SCSI hard disk drive bay), one slim-
height CD-ROM drive, and one 3.5-inch floppy disk drive.

Remote Power-On Feature (Wake On LAN)

The remote power-on function turns on the server through a network. It sends a special packet from
the management computer to a remote server to turn it on if the server is off-powered.
To enable this feature, you must select "Enabled" for each submenu in the Power Management
Setup of the Advanced menu of the BIOS setup utility, "SETUP." (See Chapter 4.)
The remote power-on feature is not available in the following cases. Press the POWER/SLEEP
switch once to start the OS, and turn off the server in an appropriate procedure.
Abnormal previous system shut-down
No power supply to the server (due to turned-off breaker, disconnected power cord, power
blackout, etc.)
The optional peripheral device bay can include two 5.25-inch