NEC EXP200 User Manual page 296

10-10 Internal Cabling Diagrams
If SCSI hard disk drives are installed and the SCSI device is desired to be controlled by a controller
other than that for the hard disk drives, the optional SCSI controller and internal SCSI cable are
required. The installed SCSI controller can be connected with both internal and external SCSI
devices.
The SCSI controller is connected with the 5.25-inch device as shown in the figure below.
[Standard configuration]
To external SCSI file
device if no internal
SCSI file devices are
connected
If the SCSI cable sold separately has the connector for terminating the SCSI connection, make the
termination setting of the 5.25-inch device invalid. SCSI cables sold separately are required for
external devices. Set the SCSI ID of each device uniquely.
Power
Terminator
supply
Mother board
SCSI
controller
Floppy disk IDE
drive
IDE cable
SATA cable
SCSI device
CD-ROM drive
Floppy disk drive
LED
connector
FDD cable SCSI cable
5.25-inch device bay
3.5-inch device bay
Fourth hard disk drive
Third hard disk drive
Second hard disk drive
First hard disk drive