Updating The System - Installing Service Pack - NEC EXP200 User Manual

5-50 Installing the Operating System with Express Setup

Updating the System - Installing Service Pack -

IMPORTANT: Without applying Service Pack and applying Service
Pack 1, 2, or 3 to this system are not supported. If you install
Windows 2000 CD-ROM which contains ServicePack 4 to your
system, you do not have to apply Service Pack 4 again.
NOTE: If you run the Update of System with the MO device
connected, refer following attention.
<If you insert the MO media>
Remove MO media from the MO device immediately after clicking on
[Restart Computer].
<If you do not insert the MO media>
If the message "There is no disk in the drive. ..." is shown during the
Update of System, click [Cancel] or [Continue] and continue the
update.
Update the system in the situation below:
Modified system configuration.
Recovered the system using recovery process.
Log on to the system with the account that has administrative authority (e.g. Supervisor) and insert
the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
[Setup Software] in [Master Control Menu] screen appears, so left-click the item. Click [Update the
System] from the menu and the setup will start. After that, follow the message to continue the setup
process and apply Service Pack.