NEC EXP200 User Manual page 335

7.
Select the proper SCSI Adapter and press Enter.
– INITIO INI-A10XU2W SCSI Host Adapter
(When N8103-65F board is installed.)
– Adaptec Ultra320 SCSI Cards (Win XP/Server 2003 IA-32)
(When N8103-75 board is installed.)
– LSI MEGARAID Products for Windows 2003 (x86)
(When N8103-80F board is installed.)
– Promise FastTrak S150 SX4100(tm) Controller-Intel x86 platform
(When N8103-89 board is installed.)
– Promise SuperTrak EX8350/EX8300(tm) Controller-Intel x86 platform (When N8103-
101 board is installed.)
– Adaptec Embedded Serial ATA HostRAID Driver For Windows 2000/XP/2003
(When Adaptec HostRAID (S-ATA) is installed.)
Continue performing tasks according to the subsequent messages that appear.
8.
When the following message is shown, press Enter to start "Welcome to Setup".
9.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
– Windows Server 2003 has installed: Go on the step 13.
– Windows Server 2003 R2 has installed: Go on the step 10.
10.
When Windows Server 2003 R2 has been installed, the [Windows Setup] screen will be
displayed after logged on to the system.
IMPORTANT:
In this case, the [Windows setup] screen may not be displayed.
Be sure to install Microsoft Windows Server 2003 R2 DISC 2
according to the following procedures.
You can install Microsoft Windows Server 2003 R2 DISC 2 after
the application of "System update".
Be sure to install Microsoft Windows Server 2003 R2 DISC 2. In
this case, note that the [Windows setup] screen is not displayed.
Installing Windows Server 2003 E-7