Safety Information - Martin MAC Quantum Profile Safety And Installation Manual

Safety Information

Read the safety precautions in this section before
installing, powering, operating or servicing this
The following symbols are used to identify important safety information on the product and in this document:
DANGER!
Safety hazard.
Risk of severe
injury or death.
Warning! The MAC Quantum Profile™ contains components that are accessible and live at high
voltage while the fixture is connected to power. These components remain under tension for up to
30 minutes after power is disconnected. Only technicians who are authorized by Martin™ and who
have access to the Martin™ service documentation for the MAC Quantum Profile are permitted to
open the fixture.
Warning! Risk Group 2 product according to EN 62471. Do not view the light output with optical
instruments or any device that may concentrate the beam.
This lighting fixture is for professional use only and must be installed by a qualified technician. It is not for
household use. It presents risks of severe injury or death due to fire hazards, electric shock and falls. It
produces a powerful, concentrated beam of light that can create a fire hazard or a risk of eye injury if the
safety precautions below are not followed.
Read this manual. Install, operate and service the fixture only as directed in this manual, or you may create
a safety hazard or cause damage that is not covered by the product warranty. Follow the safety precautions
and observe all warnings in this manual, in the MAC Quantum Profile User Guide, and printed on the fixture.
The latest versions of this Safety and Installation Manual and the MAC Quantum Profile User Guide are
available for download from the MAC Quantum Profile Product Support page on the Martin™ website at
www.martin.com. Before you install, operate or service the MAC Quantum Profile, check the Martin™
website and make sure that you have the latest user documentation for the fixture. Document revisions are
indicated at the bottom of page 2.
Respect all locally applicable laws, codes and regulations when installing, powering, operating or servicing
the fixture.
If you have questions about how to operate the fixture safely, please contact your Martin™ supplier or call
the Martin™ 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Do not remove any cover from the fixture except as described under "Service and maintenance" on
page 12.
• Disconnect the fixture from AC power before servicing it and when it is not in use.
• Ensure that the fixture is electrically connected to ground (earth).
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• The power input cable must be rated 20 A, hard usage type and heat-resistant to 90° C (194° F)
minimum. It must have three conductors and an outer cable diameter of 5 - 15 mm (0.2 - 0.6 in.). In North
DANGER! WARNING!
Hazardous Fire hazard.
voltage. Risk of
lethal or severe
electric shock.
WARNING!
product.
WARNING!
Burn hazard. Hot
surface. Do not
touch.
WARNING! WARNING!
Refer to user
Intense light
manual.
emission.