Bsel Jumper Settings - Intel Core 2 Duo Processor User Manual

Reference
# Designator
26 J8H1 Boot BIOS Strap
27 J9C1 PROGRAMMING SPI1
28 J9D1 PROGRAMMING SPI0
29 J9F1 KSC Enable
30 J9G2 Boot Block Programming
31 J9H1 NMI
32 J9H2 SATA interlock switch for port1
33 J9H3 LID Position
34 J9H4 Virtual Battery
Note: A jumper consists of two or more pins mounted on the motherboard. When a jumper
cap is placed over two pins, it is designated as 1-2. When there are more than two
pins on the jumper, the pins to be shorted are indicated as 1-2 (to short pin 1 to pin
2), or 2-3 (to short pin 2 to pin 3). When no jumper cap is to be placed on the
jumper, it is designated as 1-X.
4.3.2

BSEL Jumper Settings

The jumper settings in Table 19 are provided to accommodate frequency selection for
the processor Power On and Reset Push Buttons.
52
Description
Development Board Physical Reference
Default
Setting
1-2
1-X
1-X
1-2
1-2 (Normal Operation)
1-X
1-2 (Present)
1-X
1-X
Development Kit User's Manual
Optional
Setting
1-X PCI to LPC
1-2 Program SPI-0
1-2 Program SPI-1
1-X
1-X to Program the H8
1-2 Disabled
1-X Disabled
1-2
1-2