Using The Controls - Roksan Audio Kandy K2 BT User Manual

USING THE CONTROLS

MODE CONTROL
The MODE button on the Front Panel
• It activates the amplifier from Standby.
the amplifier in and out of standby.
• Pressing the MODE button once with the amplifier activated will mute/lower the volume level by 20dB. The
MODE indicator light will change to AMBER. The amplifier remains fully functional in this mode. Another signal
press, un-mutes the amplifier and the MODE indicator light will change to GREEN.
NOTE:
First time when you bring the Kandy out of STANDBY mode after switching it ON at the Mains, the input
selector will default to CD (as described previously.)
Subsequently, bringing the Kandy out of the standby from standby using the MODE or the POWER (Remote handset)
buttons, will restore the inputs that was selected before it was put into Standby.
VOLUME CONTROL
The VOLUME control is a precision device. It follows algorithmic law so that its response approximates that of the human
ear. There is an indicator on the volume control to show the appropriate volume setting.
INPUT SELECTOR BUTTON
The INPUT Selector Buttons
the amplifier by shifting through the Inputs. Pressing the Forward Button
Pressing the Backward Button
Whenever an input is selected the appropriate indicator light will illuminate.
NB: To select the Bluetooth input, press the Bluetooth on/off button (12). The Bluetooth on light will illuminate when
selected.
BLUETOOTH CONNECTION & PAIRING
Make sure your device's Bluetooth is enabled and press the Bluetooth on/off button
the amplifier. This will select the Bluetooth source and when your device has found the amplifier, 'ROKSAN K2 BT' will
appear on your device. Next, connect to pair your device. You are now ready to stream music to the K2 BT from the
paired device. If your device is apt-X compatible and contains high resolution audio files, then these will be streamed in
the original high quality bit rate through the K2 BT.
KNOWING YOUR KANDY
When you first power up from the Mains Switch (refer to diagram on page 3), the amplifier goes into Standby and the
MODE indicator glows Green.
In order to reduce power consumption and heat, the power stage of the amplifier is shut down when in STANDBY mode.
If the amplifier output current exceeds its safe operating range (very low loudspeaker impedance and/or very high
volume level) the protective circuitry of the Kandy will take the amp into Standby mode. If subsequently lowered or the
loudspeakers changed, the amplifier can be brought out of Standby to resume as normal.
R E M O T E C O N T R O L
Kindly Refer to RMX-111 User Manual
Roksan Audio Ltd
CLASSIFICATION: General Use
All specifications are liable to change without notice. E&OE
(1) has the following functions:
NOTE:
(2) and (3) shift through the inputs one click at at time. They connect each signal source to
CD - AUX1 - AV - AUX2 - AUX3 - PHONO
(2) repeatedly reverses the sequence.
From the Remote Handset, only the POWER Button (3) can put
(3) repeatedly will select inputs in this sequence:
Kandy
Kandy K2 BT Integrated Amplifier User Manual
—6—
(12) located on the front panel of
K2 BT Integrated Amplifier
Version 0.1
ENGLISH