Control Board - Elation DESIGN SPOT 575E User Manual

You can set the same starting address for all fixtures or a group of fixtures, or make different address
for each fixture individually.
If you set the same address, all the units will start to "listen" to the same control signal from the same
channel number. In other words, changing the settings of one channel will affect all the fixtures
simultaneously.
If you set a different address, each unit will start to "listen" to the channel number you have set, based
on the quantity of control channels of the unit. That means changing the settings of one channel will
affect only the selected fixture.
In the case of the spot head, which is a 24 channel fixture, you should set the starting address of the first unit to 1, the
second unit to 25 (24 + 1), the third to 49 (25 + 24), and so on.

Control Board

The Control Board offers several features: you can simply set the starting address, switch on and off the lamp, run the
pre-programmed program or make a reset.
The main menu is accessed by pressing the Mode/esc-button until the display starts flashing. Browse through the
menu by pressing the Up-button or Down-button. Press the Enter-button in order to select the desired menu. You can
change the selection by pressing the Up-button or Down-button. Confirm every selection by pressing the
Enter-button. You can leave every mode by pressing the Mode/esc-button . The functions provided are described in
the following sections.
Set Dmx Address
Value Display
Set To Slave
Auto Program
Music Control
Time Information
Temperature Info
Software Version
Lamp On or Off
Automatic La-On
Lamp On Via DMX
Lamp Off Via DMX
Lamp Off No DMX
Lamp On at Temp.
Lamp Off at Temp.
A001~AXXX
PAN Moving......
Slave1,Slave2,Slave3
Master / Alone
Master / Alone
Current Time
Total Run Time
Total Lamp Time
Lamp Off Time
Clear Lamp Time
Base Temperature
Head Temperature
Ver1.0
ON/OFF
ON/OFF
ON/OFF
ON/OFF
OFF, 0FF~19M
45C, 20~79 /
130C, 80~139 /
- 9 -
XXXX(Hours)
XXXX(Hours)
XXXX(Hours)
XXXX(Minute)
ON/OFF
XX /
XXX /
DMX address setting
DMX value display
Slave setting
Auto program
Music control
Power on running time
Fixture running time
Lamp running time
Lamp off time
Clear lamp time
Temperature on the display
board of the base
Temperature in the head
Software version of each IC
Lamp on/off
Lamp on/off when Power on
Lamp on via DMX
Lamp off via DMX
Lamp off if no DMX
Lamp restart at temp.
Lamp off at temp.
V1.0 01NR