Software version
With this function , you can display the software version of the device.
• Select "Software version" by turning the encoder.
• Press the encoder, the display shows "V-X.X", "X.X" stands for the version number, e.g. "V-1.0", "V-2.6".
• Turn the encoder in order to read the version of every individual IC.
• Press the Mode/Esc-button in order to return to the main menu.
LAMP CONTROL
Lamp on/off
With this function you can switch the lamp on or off via the Control Board.
• Select "Lamp on/off" by turning the encoder.
• Press the encoder, the display shows "ON" or "OFF".
• Turn the encoder to select "ON" if you wish to strike the lamp or "OFF" in order to switch it off.
• Press the encoder to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Automatic La-On
With this function you can select if the lamp will be switched on when switching the power on. Select "ON" by turning
the encoder if you wish to enable this function or "OFF" if you don't.
Lamp on via external controller
With this function you can select if you can switch the lamp on via an external controller. Select "ON" by turning the
encoder if you wish to enable this function or "OFF" if you don't.
Lamp off via external controller
With this function you can select if you can switch the lamp off via an external controller. Select "ON" by turning the
encoder if you wish to enable this function or "OFF" if you don't.
Lamp Off if no DMX
With this function you can select to switch off the lamp off automatically if there is no DMX signal). Select "ON" by
turning the encoder if you wish to enable this function or "OFF" if you don't.
Lamp on at temp.
With this function you can set the inside temperature from which the projector will restrike the lamp after automatic lamp
shut off.
Lamp off at temp.
With this function you can set the inside temperature at which the projector will automatically switch the lamp off. Turn
the encoder to select the maximum inside temperature between 80° C and 139° C. Inside temperatures below 90° C are
not critical. 90° C and more should lead to the lamp being switched off. Please note that the outside temperature should
not exceed 45° C.
PERSONALITY
Status setting
Address via DMX
With this function, you can adjust the desired DMX-address via an external controller.
• Select "Address Via DMX" by turning the encoder.
• Press the encoder, the display shows "ON" or "OFF".
• Turn the encoder to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press the encoder to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
• On the controller, set the DMX-value of channel 1 to "7".
• Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting address between 1 and 255.
When set to "8" you can adjust the starting address between 256 and 511.
• Set the DMX-value of channel 3 to the desired starting address. If you want to set the starting address to 57, set channel
- 12 -
V1.0 01NR