Safety Instructions - Elation DESIGN SPOT 575E User Manual

·Motorized linear zoom from 16° ~ 30°
·Linear dimmer in precise speed from 0~100%
·Stepless iris , 5%~100% linear change iris, pulse iris effect
·Stepless frost, 0%~100% linear change frost
·Preset variable iris, dimmer, shutter, frost pulse effects
·Strobe effect with 1-10 flashes per second or random strobe via shutter
·Friendly colored LCD display
·Battery buffered Control Board for operation time readouts etc
·Local and remote lamp on/off
·Preset program: 8 built in programs can be called up via DMX controller
·Editable program: Edit and save the program to inside EEPROM via the control board or external
controller, up to 250 scenes can be saved and then can be run in Stand Alone or sound activated.
·Number of scenes in Program Run can be changed individually

SAFETY INSTRUCTIONS

CA UTION
Be very careful during installation. Since you will be working with a dangerous
voltage you can suffer a life-threatening electric shock when touching live wires.
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
IM PORTA NT
Damages caused by the disregard of this user manual are not subject to warranty.
The dealer will not accept liability for any resulting defects or problems.
If the device has been exposed to temperature changes due to environmental changes, do not switch it
on immediately. The arising condensation could damage the device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed.
The electric connection must carry out by qualified person.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
- 3 - V1.0 01NR