1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set the starting address to 420,set channel 1 to "7",
channel 2 to "8" and channel 3 to "164" (256+164=420).
• Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting address is set.
Run If No DMX
With this function, when the drive is not DMX signal, it runs automatism. You can select model for close, hold, auto,
music if no DMX. Default is hold.
Pan Reverse
With this function you can reverse the Pan-movement.
Tilt Reverse
With this function you can reverse the Tilt-movement.
Fine resolution
With this function, you can fine resolution switch of pan movement or tilt movement.
Pan Degree
With this function, you can select pan degree for 630 or 540. Default is 540.
Scan Feedback
With this function, you can scan feedback switch of pan movement or tilt movement.
Scan Mode Select
With this function, you can select scan mode from 1 to 4.
Mic Sensitivity
With this function, the default is 70%, you can select the desired microphone sensitivity from 0 % to 99 %.
Fans Control
With this function, you can set the speed of the running fans. The selections have auto fans speed and high fans
speed.
Temperature C/F
With this function, you can set the unit of the temperature. The selections have Celsius and fahrenheit.
Initial effect
With this function, you can adjust with which value the respective channels will start.
Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the default values
(shaded). Any edited scenes will be lost.
Reset-functions
With this function you can reset the device via the Control Board. You can select the different Reset functions by turning
the encoder.
Effect Adjust
Test function of each channel
With this function you can test each channel on its (correct) function.
Lamp adjustment (manual control)
With this function, you can adjust the lamp more easily. All effects will be canceled, the shutter opens and the dimmer
intensity will be set to 100 %. With the individual functions, you can focus the light on a flat surface (wall) and erform the
fine lamp adjustment.
- 13 -
V1.0 01NR