Load A New Application Image (Smartware) Via The Serial Link - Patton SmartNode SN4960 User Manual

SmartNode 4960 User Manual
Delete image 1 - continue (y/n)? y
... Erase from 0x60030000-0x601cc974: ..........................
RedBoot> fis create
Use address 0x01800100, size 1684402 ? - continue (y/n)? y
... Erase from 0x60030000-0x601cb3ba: ..........................
... Program from 0x00011eec-0x00011ef4 at 0x60030000: .
... Program from 0x01800100-0x0199b4b2 at 0x60030008: ..........................
... Program from 0x00011eec-0x00011ef4 at 0x60030000: .
Image successfully written to flash
RedBoot> fis list -l
Id Address Length
Entry Load Addr
--------------------------------------------------------------------
1 0x60030000 1693438
0x01800100 0x01800100
RedBoot> go
Starting 'SmartWare R2.10 BUILD28015' at 0x01800100 via 0x01800100

Load a new application image (SmartWare) via the serial link

The Bootloader supports the 'X-Modem' and 'Y-Modem' protocols to download application images via the
serial link of the console. Do the following to initiate the download:
Step Command
1 RedBoot> load -r -v -m {
xmodem | ymodem } -b
base_address
5 RedBoot> fis delete -n 1
6 RedBoot> fis create
7 RedBoot> fis list -l
8 RedBoot> go
Note
This type of download takes about 25 minutes since it uses a serial link at
only 9600 bps.
Bootloader
State Description
Version
valid SmartWare R2.10 BUILD28015
V2.10
Downloads an application image into the volatile memory
(RAM) from where the SmartNode could directly execute it.
'xmodem' or 'ymodem': Specify the protocol to be used, X-
Modem or Y-Modem
base_address: memory location where to store the application
image. Use the default address 0x1800100
Execute the above RedBoot command first, then start the trans-
fer from the terminal program with the command 'Send file via
X-Modem' (or similar).
Deletes the first application image.
Reply with 'y' to the confirmation request.
Stores the downloaded application image to the permanent
memory (flash:).
Reply with 'y' to the confirmation request.
Checks whether the image has been successfully stored,
whether it is the desired Release and Build, and whether it is
valid.
Starts the application image that was downloaded to the vola-
tile memory (RAM).
4 • Initial configuration
Purpose
36