Lubrication - Grizzly G0514 Owner's Manual

Lubrication

Most of the bearings on this bandsaw are sealed
and permanently lubricated and require no lubri-
cation. the bearings are standard sizes and can
be purchased from the grizzly parts department
when they need to be replaced.
the oil lite bearings require cleaning and relubri-
cating after every 8 hours of continuous use.
To remove and clean the bearings:
1. disConneCt BandsaW FroM poWer!
2. loosen the thumb screws in figure 55.
3. slide the oil lite bearings out of the blade
guide assembly.
4. Clean the oil lite bearings with a solvent
cleaner.
5. apply a small amount of sae 10wt oil to the
inside surface of the oil lite bearings.
6. reverse the above steps to re-assemble the
guide bearings.
Model g0513/g0514 (Mfg. since 8/02+)
thumb screws
oil lite Bearings
Blade guide assembly
figure 55. Front of upper blade guide.
-39-