Fence Adjustment; Table Alignment - Grizzly G0514 Owner's Manual

fence Adjustment

the fence face needs to be parallel to the table
miter slot.
To adjust the fence parallel to the miter slot:
1.
Move the fence to the right side of the saw
blade.
2.
loosen the 4 cap screws located on the top
face of the fence.
3. adjust the fence face parallel with the edge
of the miter slot. Carefully tighten down the 4
cap screws.
NOTICE
Adjusting the fence parallel to the miter
slot does not guarantee straight cuts. The
miter slot may need to be adjusted parallel
to the side of the blade. Refer to the "Table
Alignment" instructions.

Table Alignment

Correct table alignment is needed to achieve
accurate cuts.
To adjust the miter slot square to the blade:
1.
loosen the trunnion bolts underneath the
table.
2. place a straightedge along the side of the
blade. the straightedge should touch the
front and the back of the blade.
3.
use a fine ruler to gauge the distance
between the blade and the miter slot as
shown in figure 23. the distance you mea-
sure should be the same at both the front and
the back of the table.
-22-
4.
adjust the table in the desired direction and
secure it in position by retightening the trun-
nion bolts.
the table should also be 90˚ to the back of the
blade as shown in figure 24. if the table is not
perpendicular to the back of the blade, shim the
table in the desired direction by placing washers
between the table and the two trunnions.
Miter slot
figure 23. squaring miter slot to blade.
Blade
table
figure 24. squaring back of blade and table.
Model g0513/g0514 (Mfg. 8/02+)
square