Grizzly G0514 Owner's Manual page 53

5.
loosen the guide post lock knob, lower the
guide post to within 1" of the table top, then
tighten the knob.
6. place a machinist's square on the table next
to the right hand side of the guide post, as
shown in figure 66.
figure 66. example of checking guide post
squareness.
—if there is no gap between the square and
the guide post along its full length, no
adjustments need to be made. proceed to
"to check/adjust if the guide post is parallel
with the blade front-to-back."
—if there is a gap between the square and
the guide post, the guide post is not parallel
to the blade. go to Step 7.
7. loosen each of the four screws shown in
figure 67
⁄ turn.
1
4
figure 67. guide post adjustment screws.
Model g0513/g0514 (Mfg. since 8/02+)
8.
gently tap the lower part of the guide post in
the appropriate direction until there is no gap
between the square and the guide post.
9. tighten the screws shown in figure 67.
To check/adjust the guide post parallel with
the blade front-to-back:
1. disConneCt BandsaW FroM poWer!
2. loosen the guide post lock knob, lower the
blade guide assembly to within 1" of the table
top, then tighten the lock knob.
3.
remove the screws that secure the guide
post guard and move it up and out of the
way.
4. Measure the distance "a" between the top
front face of the guide post rack and the back
of the blade (see figure 68).
figure 68. example of measuring distance
between rack and blade at top of guide post.
5. Measure the distance "B" between the bot-
tom front face of the guide post rack and the
back of the blade (see figure 68).
—if the measurements taken in Steps 4–5
are equal, no adjustments need to be
made. go to Step 9.
—if the measurements taken in Steps 4–5
are not equal, go to Step 6.
-51-