Grizzly G0514 Owner's Manual page 27

0.004" gap
Blade
figure 28 Correct gap between the
guide bearings and the blade.
6. slide the support bearing forward against the
back edge of the blade and then back the
bearing off approximately 0.016" as shown in
figure 29. tighten cap screw #1 to secure
the bearing in place.
0.016"
gap
Blade
figure 29. Correct gap between the
support bearing and the blade.
Model g0513/g0514 (Mfg. since 8/02+)
guide Bearings
(not to scale)
(not to scale)
support Bearing
personal injury or death
can occur if the bandsaw
starts during blade guide
adjustments. Disconnect
power from the bandsaw
before performing blade
guide adjustments.
To adjust the lower blade guide:
1. disConneCt BandsaW FroM poWer!
2. loosen cap screw #1 shown in figure 30
and rotate the adjustment knob to slide the
support bearing away from the blade.
support Bearing
guide Block
assembly
figure 30. side of lower blade guide.
3. remove the cap screws shown in figure 31
and remove the blade guards.
Blade guards
thumb screws
guide Bearing shaft 1 of 2
(guide Bearings not visible)
figure 31. Front of lower blade guide.
adjustment Knob
Cap screw #1
Cap
screw #2
Cap screws
-25-