Grizzly G0514 Owner's Manual page 28

4. loosen the thumb screws shown in figure
31 and slide the guide bearings away from
the blade.
5. loosen cap screw #2 shown in figure 30
and adjust the guide block assembly until the
front edge of the guide bearings are aligned
⁄ " behind the gullet line as shown in figure
1
16
32. retighten cap screw #2.
6.
slide the guide bearings against the side of
the blade. Make sure the front edge of the
bearings are still behind the gullet line. the
gap between the face of each guide bear-
ing and the side of the blade needs to be
the same as the thickness of a dollar bill or
approximately 0.004" as shown in figure 33.
tighten the thumb screws once the guide
bearings are correctly set.
7. turn the adjustment knob shown in figure
30 to slide the support bearing forward
against the back edge of the blade and then
back the bearing off approximately 0.016" as
shown in figure 29. tighten cap screw #1 to
secure the bearing in place.
8.
re-install the blade guards.
⁄ " gap
1
16
gullet line
figure 32. Correct guide bearing alignment
against the blade.
-26-
(not to scale)
guide Bearing
Blade
0.004" gap
Blade
figure 33. Correct gap between the
guide bearings and the blade.
0.016" gap
Blade
figure 34. Correct gap between the
support bearing and the blade.
Model g0513/g0514 (Mfg. 8/02+)
guide Bearings
(not to scale)
(not to scale)
support Bearing