Dust Collection - Grizzly G0514 Owner's Manual

Dust collection

DO NOT operate this bandsaw without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended cfM at Each Dust port:
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must take into account
many variables, including the CFM rating of the
dust collector, the length of hose between the
dust collector and the machine, the amount of
branches or wyes, and the amount of other open
lines throughout the system. Explaining this calcu-
lation is beyond the scope of this manual. If you
are unsure of your system, consult an expert or
purchase a good dust collection "how-to" book.
To connect a dust collection hose:
1.
Fit a 4" dust hose over each dust port, as
shown in figure 21, and secure in place with
a hose clamp.
2. tug each hose to make sure it does not come
off. Note: A tight fit is necessary for proper
performance.
figure 21. example of dust hose attached to
dust port.
3.
attach the dust hoses to a dust collector.
Model g0513/g0514 (Mfg. since 8/02+)
fence Assembly
the threaded holes on the front and back of the
table are mounting holes for the fence rails.
To assemble the fence:
1.
Mount the rear fence rail to the table with (2)
M6-1 x 16 cap screws. If a cap screw falls
inside of the rear fence rail, remove the rail
end plug to retrieve it.
400
2.
install the front fence rail to the table with (2)
M6-1 x 20 hex bolts and (2) 6mm lock wash-
ers. Make sure the scale is face up.
3. set the fence on the front and rear rails. the
fence should easily slide across the rails.
if the fence rubs on the table surface, the
height adjustment screw on the bottom of
the fence needs to be threaded out a small
amount. this raises the riding height of the
fence.
figure 22. Fence assembly.
4. thread the handle onto the fence.
-21-