Positive Stop - Grizzly G0514 Owner's Manual

positive Stop

personal injury or death
can occur if the bandsaw
starts during table adjust-
ments. Disconnect power
from the bandsaw before
performing table adjust-
ments.
the positive stop allows the table to be quickly
and accurately returned to the horizontal (0˚) posi-
tion after being adjusted to a different angle.
To set up the positive stop:
1.
disConneCt BandsaW FroM poWer!
2.
locate the positive stop bolt under the table
as shown in figure 19.
3.
loosen the jam nut on the positive stop
bolt.
4. raise the upper blade guide to the highest
position.
Jam nut
(not visible)
figure 19. positive stop bolt and jam nut.
-20-
positive stop Bolt
5.
place a 6" square on the table surface and
determine if the blade is square to the table
surface as shown in figure 19.
— if the blade is square with the table sur-
face: lock the table into position, tighten
the jam nut on the positive stop bolt, and
adjust the scale pointer to the 0˚ position.
Continue to the next page.
— if the blade is NOT square to the table
surface: raise or lower the positive stop
bolt until the blade is square to the table
surface. When square, lock the table into
position, tighten the jam nut on the positive
stop bolt, and adjust the scale pointer to
the 0˚ position. Continue to the next page.
Blade
table
figure 20. squaring side of blade and table.
Model g0513/g0514 (Mfg. 8/02+)
square