Positive Stop - Grizzly G0514X Owner's Manual

positive Stop

the positive stop allows the table to be quickly
and accurately returned to the horizontal (0˚) posi-
tion after being adjusted to a different angle.
Installing positive Stop
1.
disConneCt BandsaW FroM poWer!
2. unlock the table tilt lock lever, tilt the table to
access the positive stop bolt installation loca-
tion, then lock the lever.
3. thread the M8-1.25 hex nut halfway onto the
M8-1.25 x 90 hex bolt (this is the positive stop
bolt).
4.
thread the positive stop bolt into the thread-
ed hole on bandsaw body, as shown in
figure 32.
figure 32. installed positive stop bolt.
5.
lower the table onto the positive stop bolt.
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
positive stop
positioning positive Stop
1.
disConneCt BandsaW FroM poWer!
2.
adjust the blade tension until the mark on the
blade tension scale is between 4 and 6.
3.
loosen the hex nut that locks the positive
stop bolt in place.
4.
raise the guide post and place a machinist's
square on the table next to the side of the
blade, as illustrated in figure 33. adjust the
table square with the blade, then secure it
with the table tilt lock lever (see figure 71 on
page 42).
figure 33. squaring table to blade.
5.
adjust the positive stop bolt against the
table and secure it by tightening the hex nut
against the trunnion bracket.
6. Check the adjustment for accuracy once you
have tightened the hex nut.
7. loosen the screw on the pointer, but do not
remove it.
8.
align the tip of the pointer with the 0˚ mark on
the table tilt scale.
9.
tighten the screw on the pointer so that the
pointer is locked in place.
-25-