Table of Contents
Advertisement
Clean up
The work table and other unpainted parts of the
Model G5049Z are coated with a waxy oil that
protects them from corrosion during shipment.
Remove the protective coating with mineral spir-
its and cloth rags. Do not use gasoline or other
petroleum based solvents because of their
extremely low flash points. Do not use chlorine-
based solvents – if you happen to splash some
onto a painted surface, you'll ruin the finish.
WARNING!
Follow the safety rules listed below when
working with solvents:
1.
Read and follow all directions and warnings
on the solvent label.
2.
Work only in a well ventilated area.
3.
Do not work near any type of open flame
(e.g., pilot lights, kerosene heaters, and so
on).
4.
DO NOT smoke while working with flamma-
ble material.
5.
Paper towels and rags from the cleaning
process are extremely combustible. Dispose
of waste towels so they do not create a fire
hazard.
G5049Z Combination Sander
Site Considerations
1.
Floor Load: Your G5049Z Sander repre-
sents a medium weight load in a small foot-
print. Most commercial floors are suitable for
the Model G5049Z. Some residential floors
may require additional build up to support
both machine and operator.
2.
Working Clearances: Consider existing and
anticipated needs, size of material to be
processed through each machine, and
space for auxiliary stands, work tables or
other machinery when establishing a loca-
tion for your sander.
3.
Lighting and Outlets: Lighting should be
bright enough to eliminate shadow and pre-
vent eye strain. Electrical circuits should be
dedicated or large enough to handle amper-
age requirements. Outlets should be located
near each machine so power or extension
cords are clear of high-traffic areas. Observe
local electrical codes for proper installation
of new lighting, outlets, or circuits.
-7-
Advertisement
Table of Contents
