Announced Transfer; Attendant Reverting; Recall Trunk Display - NEC 1232 AK Series Operation Manual

Announced Transfer

Announced Transfer automatically puts the call on System Hold so that the transferring extension can notify
the receiving extension before actually sending the call. To receive an Announced Transfer, receiving
extension just wait on the line to be automatically connected to the transferred caller. Both the transferring
and receiving extensions receive a "fast flash" Hold indication, making the call easy to identify, while all
other KTSs see a "slow flash." If the call is not sent within the Announced Transfer Recall interval, the call
then shows a "slow flash" at the receiving extension, and re-rings the transferring extension.
To make an Announced
To receive an Announced

Attendant Reverting

When hold transfer is failed because the destination telephone did not answer and returned back to
originating telephone, then the originating telephone did not answer, the call will be cut off by pre-set timer,
or transferred to Extension No.10 or the attendant extension of each tenant according to system
programming.

Recall Trunk Display

Display type key telephone can be set to the Recall Trunk Display Mode. When Hold Recall tone is heard,
the telephone will display the held Trunk line and the telephone number.
To set/reset Recall Trunk
Hold/Transfer/During Conversation
1. Press
Transfer:
2. Announce the call.
TRFR
3. Press
1. Flash Hookswitch.
2. Dial extension number.
3. Announce the call.
4. Hang up.
1. Lift handset when notified of the call.
2. Just wait on the line to be automatically connected to the
Transfer:
transferred caller.
1. Lift handset to answer a call.
2. Just wait on the line to be automatically connected to the
transferred caller.
1. Press
Display: 2. Press
3. Press
CHECK
4. Press
ICM
key, then dial extension number.
key or hang up.
SPK
key.
ICM
key.
OPAC
key.
key.
21