Attaching Dust Port - Grizzly G0512 Instruction Manual

Attaching Dust Port

To attach the dust port:
1.
Attach the dust port to the support brackets
5
with the three ⁄
washers, as shown in Figure 9, but DO NOT
completely tighten the bolts yet.
Figure 9. Dust port attached to brackets.
2.
Position the dust port approximately
from the driver roller and tighten the two
attachment bolts from step 1.
-14-
1
"-18 x ⁄ " hex bolts and
16 2
1 ⁄ " away
2
Connecting Plug to
Cord
The voltage you decide to use with your sander
will determine which plug and receptacle you
pages 6 & 7, in Section 3: Circuit
install. Read
Requirements for more information.
Install the plug and receptacle now.
G0512 Edge Sander