Table of Contents
Advertisement
Start Up
Starting the machine:
1.
Read the entire instruction manual.
2.
Make sure all tools and foreign objects have
been removed from the machine.
3.
Review Section 3: Circuit Requirements
(Page 6).
4.
Keep your finger on the STOP button at all
times during the test run.
Starting the machine:
Press the START button to turn the machine ON.
The machine should run smoothly with little or no
vibration.
G0550/G0551 15" Planer
Loose hair and clothing
could get caught in
machinery causing seri-
ous
personal
injury.
Keep
loose
clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate your machine.
However, because of the many variables
involved with shipping, we recommend that you
at least verify the following adjustments to ensure
the best possible results from your new machine.
Step-by-step instructions on verifying these
adjustments can be found in Section 8: Service
Adjustments.
Factory adjustments that should be verified:
1.
Table Adjustment (page 29)
2.
Thickness Scale (page 30)
3.
Knife Setting (page 32)
4.
Chip Breaker (page 33)
5.
Feed Roller Height (page 34)
6.
Bed Roller (page 35)
7.
Feed Roller Pressure (page 36)
8.
Chip Deflector (page 37)
-19-
Advertisement
Table of Contents
