Table of Contents
Advertisement
Dust Port
Components and Hardware Needed: ....Qty
Dust Port ........................................................1
Phillips Head Screw M6-1 x 12......................6
Tools Needed:
Phillips Head Screwdriver ..............................1
It is important to install a dust collection system to
the dust port.
To install the dust port:
1.
Do not connect the planer to a power
source!
2.
Place the dust port above the outfeed table.
See Figure 9.
3.
Secure the dust port with the Phillips head
screws provided.
Figure 9. Dust port installed.
-16-
Handwheel
Components and Hardware Needed: ....Qty
Handwheel ....................................................1
Handwheel Handle ........................................1
Hex Nut M10-1.5 ............................................1
Flat Washer 10mm ........................................1
High/Low Label ..............................................1
Tools Needed:
12/14mm Combo Wrench ..............................1
The handwheel is used to raise and lower the
planer cutterhead.
To install the handwheel:
1.
Do not connect the planer to a power
source!
2.
Place the handwheel over the keyed shaft
shown in Figure 10. Make sure the keyway
in the handwheel lines up with the key in the
shaft.
3.
Secure the handwheel with the hex nut and
washer.
4.
Attach the handle to the outer edge of the
handwheel.
5.
Install the High/Low label around the hex nut.
Key
Figure 10. Installing handwheel.
G0550/G0551 15" Planer
Advertisement
Table of Contents
