Table of Contents
Advertisement
Extension Rollers
Components and Hardware Needed:
Extension Rollers ..........................................2
Tools Needed:
12/14mm Combo Wrench ..............................1
Allen Wrench 4mm ........................................1
To install the extension rollers:
1.
Do not connect the planer to a power
source!
2.
Remove the three hex bolts and washers
from below the outfeed and infeed tables.
3.
Position the extension rollers over the holes.
4.
Finger-tighten the hardware removed in step
2 to secure the extension rails to the planer
as shown in Figure 11.
Level Adjust
Setscrews
Figure 11. Extension rollers.
G0550/G0551 15" Planer
Qty
Hex Bolts
5.
Loosen the bed roller setscrews and turn the
eccentric shaft so the table rollers are
beneath the table surface. See Figure 12.
Figure 12. Bed roller.
6.
Use a straightedge to check table-to-exten-
sion roller alignment as shown in Figure 13.
Figure 13. Checking extension roller alignment..
7.
Adjust the leveling setscrews shown in
Figure 11 if the table and extension rollers
are not flush.
Setscrews
-17-
Advertisement
Table of Contents
