Troubleshooting - Procedures - Sundance Spas CAMEO Installation & Owner's Manual

14.0 Troubleshooting - Procedures

In the unlikely event your hot tub is not working the way you believe it should,
please first review all installation and operating instructions in this manual and
check the message on the panel display; second, if you are still not satisfied
it is working properly, please follow the appropriate troubleshooting instruc-
tions.
PROBLEM
NONE OF THE
COMPONENTS
OPERATE (i.e.
pump, blower, light)
Communication between the control panel and/or
remote control panel and circuit board is faulty.
Contact your dealer or service organization.
"WATCHDOG" (Hot tub is deactivated)
A problem has been detected which could cause
damage to the hot tub or its components. Contact
your dealer or service organization.
OPEN SENSOR (heater disabled) OR
SHORTED SENSOR (hot tub is deactivated)
The high-limit temperature sensor is non-functional. This
must be repaired only by a dealer or qualified service
organization.
OPEN OR SHORTED SENSOR (heater disabled)
The main sensor is non-functional. This must be
repaired only by a dealer or qualified service
organization.
CLOSED OR SHORTED FLOW SWITCH ON
SYSTEM STARTUP (system disabled) Flow switch
is non-functional. This must be repaired only by a
dealer or qualified service organization.
PROCEDURE
Check the control panel lights.
1. If there are letters or symbols displayed on the
screen, refer to the previous section to
determine meaning and action required.
2. If nothing appears on the screen:
a. Check the household circuit breaker.
b. Contact dealer or authorized service center.
Page 45