Selecting Standard Or Economy Skimming/Heater Mode; Preset Skimming/Heating Cycles; Clean-Up Cycles - Sundance Spas CAMEO Installation & Owner's Manual

programmed skimming/heating cycle is running (unless in summer logic;
see note below). Note: this mode consumes less energy than the standard
mode outlined above.
9.3 Selecting Standard or Economy Skimming/Heating Mode
Press the MODE button to select either "Standard" or "Economy" skim-
ming/heating mode. The control panel's indicator on the right side of the
LCD changes to indicate which mode is selected. When an automatic
skimming/heating cycle activates, the LCD screen displays the following
message:
Summer Logic: In warm weather, the water temperature in the hot tub may
exceed the set temperature. This condition may occur due to heat transfer-
ence from the main pump and 24-hour circulation pump. If the water tem-
perature is higher than 95°F (35°C) and rises two degrees above the set
temperature, a "Summer Logic" condition occurs that deactivates the circu-
lation pump and ozonator (if equipped). This safety feature cannot be
altered! The circulation pump and ozonator will remain off until the water
temperature cools to the set temperature (except between12AM-2AM when
the circulation pumps runs for it's mandatory 2-hour "clean-up" cycle). To
help prevent a "Summer Logic" condition, it may be necessary to reduce
skimming/heating cycle and/or circulation pump run times in warm
weather.

9.4 Preset Skimming/Heating Cycles

Your hot tub comes with four 30-minute skimming/heating cycles already
programmed in, beginning at 6:00 a.m., noon, 6:00 p.m., and midnight.
You can easily change the start time, or the cycle length for any of these
cycles to suit your individual needs by following the steps in section 10.2,
page 32.
9.5 Clean-Up Cycle
The clean-up cycle is once per day in both Standard and Economy mode
at 12:00 PM for two minutes. This is not user programmable. Pump #2
and blower activate for one minute to circulate any water in the plumbing.
After 1 minute they both go off and Pump #1 runs for 1 minute. If the
skimming/heating cycle is also set at 12:00 PM, pump #1 will continue to
run for the duration of the cycle.
FILTER
CYCLE ON
Page 31