Power Requirements - Sundance Spas CAMEO Installation & Owner's Manual

7. Select the power supply entrance you want to use (Figure A, page 10)
and remove the short cabinet panel from the front of the hot tub to allow
you to feed the cable through to the control box. Install the cable with
connector through the large opening provided in the bottom of the
control box.
8. Connect wires, color to color, on terminal blocks TB1 and TB3 (Figure C,
page 10). TIGHTEN SECURELY! All wires must be hooked up securely or
damage could result.
9. Install control box door and screws and reinstall the cabinet side panels.

6.0 Power Requirements

Sundance hot tubs are designed to provide optimum performance and flexi-
bility of use when connected to the maximum electrical service as listed
below. However, they are shipped configured for the most commonly pre-
ferred electrical connection -- 50A, 240V
If you prefer, your Sundance dealer can perform a minor circuit board modi-
fication to allow the hot tub to accept different electrical service. The opera-
tional considerations of these modifications are listed in the footnotes below.
CAMEO, OPTIMA, MARIN and ALTAMAR Models
Voltage
Current Draw
Number of Wires
Circuit Breaker
CAPRI Models
Voltage
Current Draw
Number of Wires
Circuit Breaker
*
In 50A configuration, the heater will not operate while both pumps are
operating at high speed. Note: pump #2 runs only in high speed.
Page 12
**
240V/30A
240 VAC
24A
Three
30A, 2-pole
**
240V/30A
240 VAC
24A
Three
30A, 2-pole
*
*
240V/50A
240 VAC
40A
Three
50A, 2-pole
*
240V/50A
240 VAC
40A
Three
50A, 2-pole
***
240V/60A
240 VAC
48A
Three
60A, 2-pole
***
40V/60A
N/A