Display Problems - Getac P470 User Manual

Make sure that the other device is not in "Hidden" mode.

Make sure that both devices are compatible.


Display Problems

Nothing appears on the screen.
During operation, the screen may automatically turn off as a result of

power management. Press any key to see if the screen comes back.
The brightness level might be too low. Increase brightness by

pressing the
The display output might be set to an external device. To switch the

display back to the LCD, press the
Display Settings Properties of Windows Vista (via settings in Display
Properties of Windows XP).
The characters on the screen are dim.
Adjust the brightness and/or contrast.

Bad dots appear on the display at all times.
 A small number of missing, discolored, or bright dots on the screen
are an intrinsic characteristic of TFT LCD technology. It is not
regarded as a LCD defect.
Resolution cannot be adjusted to desired setting.
Make sure that the device driver is installed correctly.

The external monitor displays nothing.
Make sure that the monitor is turned on.

Make sure that the monitor's signal cable is properly connected.

Switch the display to the monitor by pressing the

through the Display Settings Properties of Windows Vista (via
settings in Display Properties of Windows XP).
Troubleshooting
Fn+F7
hot key.
Fn F5
+ hot key or through the
Fn F5
+ hot key or
8-5